LM096/FUT096 Touch Screen RGBW Remote Control

caractéristiques du produit

This manual describes two types of RGBW remote controls used for our RGBW product.
Both of them have the same functions but different designs. Each remote control can control the LED lights up to four different zones, change the color, dim/brighten the lights, warm/cool white, and different programs. In this manual.

Paramètres techniques

Product Name: Touch screen RGBW remote control
Model No.: LM 096
Voltage: 3V(AAA * 2PCS)
Transmission Frequency: 2.4GHz
Modulation Method: GFSK
Transmitting Power: 6dBm
Standby Power Consumption: 20uA
Control Distance: 30m
Size: 52.5*21*120mm

Products Key Diagram

Remark: Hold “I” to get white mode. Under white mode, press ‘S-‘ to get warm white, and press ‘S+’ to get cool white. Under color mode, press‘S+/S-‘ for saturation control. When pressing ‘M’, S+/S- can adjust the speed of the dynamic modes.

To dim all RGBW lights at once or change the color, first press “Master ON”. To do this with individual lights, first press “Zone ON”. Secondly, choose the color or brightness according to the color ring or brightness ring.

Linking&Unlinking

Remark: The light can be working after linking with the remote controller.

Linking Instructions

Noter: If the light does not blink slowly, the linking failed, Pls switch off the light again, and follow the above steps again.

Unlinking Instructions

Noter: If the light does not blink quickly, the unlink fails, pls switch off the light again, and follow the above steps to unlink again.

Grouping of several lights

You can add an endless number of lights to a zone on the 4-channel remote by linking the lights to different zones. This way you are completely flexible in creating different group combinations. Below you can see some grouping examples.

Remarque:
1. The user can re-program freely as needed. One remote can control countless lamps or controllers, but one lamp or controller can only be controlled by four remotes ( Max ).
2. Please check the battery installation and controller ( totally discharge the power ), when you program after switching off and switching on.

Attention
1. In the use of the remote, if the indicated lamp blinks quickly, pls change the
battery in time. Pls, don’t use the poor quality batteries to avoid the leaking of battery
liquid to damage the remote controller.

2. Please keep your finger off the touch ring when installing the batteries, to improve
its sensitivity, and use the remote ( 3 seconds later ) after the batteries are installed.
Please reinstall the batteries, if the fouch ring is found low-sensitivity.

3. This 2.4GHz remote control system is a precise electronic product; don’t use it in
humid, high temperature, dust, and high voltage environment; Saving it indoor, dry
and no static electricity environment.

4. PIs don’t use the remote controller on the wide-range metal or strong electromagnetic
wave area, otherwise, it will badly affect the controlling distance.