There are some customer ask some questions about the IC addressable led strip light, and also it related to the IC controller, I’d like to introduced our T-1000S SD card controller to you~ Hope you can learn something about it~
T-1000S System features：
1、32—256 Gray level，Support software Gamma correction.
2、Support the rules and special-shaped handle.
3、Single-port output，can support 2048 pixels.
4、Off-line(SD Card) control, play back content stored in the SD card.
5、T-1000S store a maximum of 16 programs，copy multiple files to the SD card in order,
after formatting the SD card as “FAT” format.
6、The program must be named in orders . just as ：00_1.led, 01_1.led, 02_1.led.
7、Compatible with single line or double line chips.
NOTE：1. When T-1000S controller control less than 512 lamps the frame rate can reach 30fps. When T-1000S
control more than 512 lamps and less than 2048 lamps the frame rate will slow down automatically.
2. T-1000S must use the new software LedEdit 2012.
1. Multiple T-1000S controllers can be cascaded together and work synchronously.
2. T-1000S one TTL(SPI) signal and one RS485 signal port output，can control 2048 pixels/lamps；
3. When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the
controller. If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and
GND of the controller.
4. If you need to use RS485 signal you need to connect controller A interface with LED lamps A (DMX+), controller B
interface with LED lamps B(DMX-),
5. If you need to control a new IC type by the controller， software code mode is：T-1000-IC model.
Special parameters
Memory card：
type：SD card（suggest using high-speed SD card）
Capacity：128MB—2GB
Format：FAT
Store file：*.led
Physical parameters：
Working temperature ：-30℃—85℃
Working voltage：DC5V / DC7.5-24V
Working power：1W
size: L165mm×W80mm×H30mm
weight: 0.35KG
signal port: 3pin connect port
Note:
Before copy files to SD card , The SD card must be formatted as FAT format.
The SD card in controller can not be hot-swappable, plug the SD card every time, you must first disconnect the
power supply
