Regarding the IC led strip light controller, i have introduce the T1000S to you last week, hope the information could for your reference. I’d like to recommend the T-8000A-TTL to you~~
T-8000A-TTL System Features
1. 32—256 Gray level，Support software Gamma correction。
2. Support the rules and special-shaped handle.
3. Eight–port output，every port can support 512-1024 pixels。
4. Off-line (SD Card) control, can be multiple controllers used in combination, play back content stored in
the SD card.
5.T-8000A store a maximum of 16 programs，copy multiple files to the SD card in order,after formatting the
SD card as “FAT” format.
6. The program must be named in orders ,just as ：00_1.led, 01_1.led, 02_1.led.
7. Compatible with single and dual ICs, if you control a single line IC LED lights, without being connected
to the CLK line.
8. New T-8000A have a screen, the controller can be encrypted to limit the times of use.
NOTE： 1.When T-8000A controller control less than 512 lamps the frame rate can reach 30fps. When
T-8000S controls more than 512 lamps and less than 1024 lamps the frame rate will slow down
automatically.
Physical parameters：
Working temperature ：-30℃—85℃
Working voltage：DC5V
Working power：3W
Size：L200mm×W170mm×H50mm
Weight：0.8KG
Signal port：3pin connect port
Question 1：After power，the T-8000S ERROR indicator has been flashing without
display output
answer：The ERROR indicator has been flashing means the controller did not read the card correctly, possible
problems:
①SD card is empty, with no effect file.
②The effect file in the SD card and the controller model are not match, please choose correct controller
model in LedEdit and then re-create the effect file *led.
③SD card did not format to FAT before copy effect files.
④Please check the supply power voltage, the controller can be individually powered to exclude power
reasons
⑤Changing the SD card and then test to exclude the possibility of a bad SD card
Question 2: The controller is powered on, the indicator is normal, but the lamps have no
effect changeAnswer: The reasons for this are as follows:
① Check if the lamp′s signal line and the controller connected correctly
② If the TTL signal is received, the lamp and the controller must be common ground, that means
connect the lamp′s and the controller′s ground wire together
③ Check if the model chose during making display files on the SD card match the chips used in the
lighting
Question 3：Controller and light connected, after. Lamps flicker. Controller indicator to
normal.
Answer：①The ground wire is not connected between the controller and lighting.
②The file in SD card is bad, Chip model does not match with the actual.
③Insufficient power supply.
Question 4：The SD card can not be formatted.
Answer：①First make sure the SD card on the side of the protection switch is already open.
②SD card reader is broken
③Do all of this can’t deal with the question. Change the SD card tests again.
